Gaggia Accademia (Pre 2022): Brew Pump Replacement

Learn how to replace the brew pump of a Gaggia Accademia. If your brew pump is leaking, damaged, or not working, this step-by-step tutorial takes you through the process from start to finish, including outer housing removal and re-installation.

Please note that flow issue do not necessarily imply that anything is wrong with the pump. If you're unsure if the pump is working, consult our article on Pump Test and Ventilation.

---

Gaggia Accademia: How to Replace the Brew Pump

1. Introduction (00:00)
2. Tools Required - Case (00:20)
3. Note Grind Setting (01:18)
4. Remove Top Screws (01:45)
5. Remove Upper Housing (02:36)
6. Remove Wires (03:45)
7. Remove Side Panel Screws (04:20)
8. Remove Side Panels (05:10)
9. Brew Pump Replacement (06:25)
10. Tools Required - Brew Pump (06:40)
11. Pump Location (08:00)
12. Remove Power Board Cover (08:25)
13. Remove Wires (09:05)
14. Remove Mount/Bracket (09:20)
15. Remove Pump (12:15)
16. Disconnect Pump Wires (13:10)
17. Remove Water Lines (15:00)
18. Cut/Remove Pinch Clamp (15:30)
19. Remove Pump (17:15)
20. Remove Pump Elbow (18:00)
21. Install Pump Elbow (18:52)
22. Install New Pump (20:32)
23. Install Water Line (21:15)
24. Install Pinch Clamp (22:45)
25. Install Pump Wires (23:25)
26. Mount Pump (24:10)
27. Install Mount/Bracket (24:36)
28. Install Power Board Cover (26:35)
29. Connect Tube To Tank Holder (28:10)
30. Install Housing (29:00)
31. Install Back Panel (29:43)
32. Install Side Panels (30:23)
33. Install Top Panel (34:18)

Associated Parts:

• Gaggia Ulka Pump Eap5/S 120V-60Hz
• 9.5 mm Oetiker Pinch Clamp

Failure of normal wear and tear items such as group gaskets, seals, and shower screens are not covered under warranty. Issues due to scale build-up or lack of maintenance are not covered.