Gaggia Anima: Internal Spout Chamber Cleaning

Learn how to clean out the internal spout chamber of all Gaggia Anima models. This cleaning is recommended if you are noticing debris dispensed from your spouts or Uneven Flow that cannot be resolved with the steps in that article.

---

How to Clean the Internal Spout Chamber

1. Introduction (00:00)
2. Remove Trim (01:22)
3. Remove Display Cover (02:25)
4. Remove Spout Cover (04:08)
5. Remove Face Plate (04:55)
6. Remove Steam Arm (Base Model) (05:30)
7. Remove Face Plate (08:00)
8. Remove Ribbon Cable (08:35)
9. Remove Button/Screen Assembly (09:40)
10. Remove Top Cover (10:18)
11. Clean Internal Spout Chamber (15:36)
12. Diagnosing a Spout Chamber Clog (15:45)
13. Remove Spout Chamber (17:45)
14. Open Spout Chamber (19:20)
15. Assemble Spout Chamber (22:00)
16. Preventing Spout Clogs (22:37)
17. Install Spout Chamber (23:35)
18. Reassemble Housing (26:19)
19. Install Door (27:00)
20. Water Sensor Wiring (27:27)
21. Attach Waterline (28:25)
22. Grind Setting (29:05)
23. Install Hopper Sensor (29:50)
24. Install Top Cover (30:15)
25. Install Control Panel (34:10)
26. Install Face Plate (36:10)
27. Install Spout Components (37:10)
28. Install Display Cover (39:45)
29. Install Trim (41:30)
30. install Steam Arm (Base Model) (42:30)